Wastewater Compatible – The low COD and BOD levels make ActiveEco SX Descaler an excellent choice for areas where wastewater systems are used. It is still recommended that pH readings are taken before release to ensure that wastewater pH readings comply with local water board recommendations.
Biodegradable – ActiveEco SX Descaler is biodegradable and phosphate-free.
Safe to Use –Formulated as a non-dangerous good for land transport and storage.
Does not contain traditional acids – No Hydrofluoric, Hydrochloric, Phosphoric, Sulphuric, Sulphamic, Nitric, Citric, Oxalic or Glycolic Acids.
Always pre-test in an inconspicuous location for substrate sensitivity to chemicals.
- Dilute ActiveEco SX Descaler 1:4 with water and apply to the surface being cleaned.
- Dwell time will depend on the application. Increase dwell time for thick scale build-ups.
- If it is a surface scale; agitate and rinse thoroughly with a high-pressure washer or hose. For pipework recirculate the chemical through the pipework then follow with a clean water rinse.
CAUTION: ActiveEco SX Descaler has dramatically lower corrosive properties in comparison with traditional acid cleaners in respect of both ferrous and non-ferrous metals. When used as directed, negligible corrosion occurs and even when used undiluted the level of corrosion to ferrous metals is almost imperceptible. However, it should be noted that ActiveEco SX Descaler has a low pH and corrosion will occur on metals submerged in ActiveEco SX Descaler for extended periods. Polished metals may show markings. Always pre-test the surface before use.
Read and understand the Safety Data Sheet before use.
Not classified as dangerous goods for land transport according to the ADG code.